INON

Housing Options

X-2 Lanyard Plate

[discontinued]

X-2 Lanyard Plate
Set-up image

Set-up image

Set-up image

Set-up image


Attaching this plate on INON X-2 for EOS6D, X-2 for EOS70D or X-2 for EOS80D VC housing utilizes to use commercially available lanyard (carry belt).
The plate is attached on the "Base Adapter Fixing Screw Hole (M6)" of the compatible housing by screws or by compatible INON arm adapter.
Supplied rubber grommet prevents uncomfortable clinking noise between this product and metal hook from recording when shooting video as well as scratching the housing body.
 
Weight: [air]52 g/1.8 oz.  [underwater] approx.42 g/1.5 oz.
 
Compatible [X-2] series Housing (*1)
X-2 for EOS6D, X-2 for EOS70D, X-2 for EOS80D VC
 
Compatible arm system products (*2)
Multi Direct Base IIa
Multi Direct Base II WB
Multi Direct Base II Long
Shoe Base Adapter X-2 + Shoe Base
M6 Plate Direct Base III+ Direct Base III
M6 Plate Direct Base III+ Direct Base YS RT
 

(*1) It is possible to attach this product to X-2 for EOS10D, X-2 for EOS20D, X-2 for EOS30D, X-2 for EOS50D/40D or X-2 for EOS60D but it requires to remove pre-installed "Lanyard hook". Please consult with your purchasing dealer. Not compatible with an INON housing which has done "Sync Connector Installation".
(*2) Attaching "ClampⅢ", "Z Joint" or "Light Holder products" may interfere full movement of the lanyard.

A spring snap hook installed on the X-2 Lanyard Plate (with grommet)

A spring snap hook installed on the X-2 Lanyard Plate (with grommet)

A split ring installed on the X-2 Lanyard Plate

A split ring installed on the X-2 Lanyard Plate

A carrying rope attached on the X-2 Lanyard Plate

page top